View Single Post
Old 10/03/2020, 10:05 AM   #6
slief
RC Sponsor

 
slief's Avatar
 
Join Date: Sep 2009
Posts: 14,125
Quote:
Originally Posted by chema View Post
Thanks again Slief. I'll try both tricks and check if I can raise the break line without much seepage between the body and the cup
Just make sure to apply the silicone grease only to the o-ring and perimeter and a very thin layer to the flange on cup side . If you get some inside the neck, it will likely cause the foam along the side to break down back into water so don’t apply so much that it squishes out into the inside of the neck. Just a very thin layer that helps provide an additional seal.


__________________
Director Customer Support Royal Exclusiv USA
For All Royal Exclusiv & Bubble King questions please refer to our Sponsor forum: http://www.reefcentral.com/forums/fo...play.php?f=745

Current Tank Info: 480G display mixed reef, 90G sump, 90G refugium, 60G display refugium. Check out my build thread: http://www.reefcentral.com/forums/showthread.php?t=1783476
slief is offline   Reply With Quote