View Single Post
Old 10/29/2020, 05:01 AM   #7
chema
Registered Member
 
Join Date: Aug 2005
Location: Spain
Posts: 208
Quote:
Originally Posted by slief View Post
Just make sure to apply the silicone grease only to the o-ring and perimeter and a very thin layer to the flange on cup side . If you get some inside the neck, it will likely cause the foam along the side to break down back into water so donít apply so much that it squishes out into the inside of the neck. Just a very thin layer that helps provide an additional seal.
Slief: your recommendation worked like a charm. Just with the silicone grease, with no weight added, I have been able to increase the water column inside the neck and get a larger volume of skimmate.

Thanks again


chema is offline   Reply With Quote